Description

Kenzo Tire pressure monitoring system with 6 sensors save gas,forsee air leakage,reduce tire wearout,balance tire pressure,ensure safety driving

How to set the sensors into correct tire? 

1. Turn on your monitor(press the right button for 5seconds until monitor is on)

2. Press “set” button for 3~5 seconds(no release) until the monitor enter into parameter mode, and press left button or right button to the page which you can see “on” near the tire or two “–” near the tire.

3. Press “set” button one time, the tire and “–” flashing, then take out the tire(which number is corresponding to the flashing tire). For example, “1” sensor is corresponding to left front tire. and you should tighten the sensor into the tire, then release, repeat 1 or 2 times, you will see “–” turns into “on”, then this sensor is matched to the tire.

4. Repeat step 3 to other sensors until all sensors matched.

5. After pairing successful, Press “set” button until 3~5seconds to exit to standby mode.

Note: Please power on the monitor first. Otherwise, The pressure and degree may show up on the monitor after a long time.

 

Displayer Parameter ： 

• Working Temperature:(-20℃-80℃)
• Storage Temperature:(-30℃-85℃)
• Input Voltage:DC5V
• Transmitting Frequency:433.92MHz
• Size( L*W*H )mm:119*34*24mm
• Weight:104g

Sensor Parameter ： 

• Working Temperature:(-40℃-105℃)
• Storage Temperature:(-40℃-120℃)
• Pressure Range:0-116psi（0-8bar）
• Pressure Precision:±1.5PSI（±0.1bar）
• Temperature Precision:±3℃
• Transmitting Power:<10dbm@50Ω
• Transmitting Frequency:433.92MHz
• Battery Life:2 years
• Size:Height:15mm;Diameter:23mm
• Weight:9.5g